Working on rebuilding a monoprice mini with ramps on an Arduino Mega.

This was my first printer, it served admirably until the stock board went. Haven't been taking a lot of WIP photos, at this point it is pretty well wired up.

• New RAMPS 1.1.4 on an arduino mega
• TL Smoother 1.0 on all four motors
• Replaced the heater block, nozzle and throat so now the nozzle sits a lot lower than stock. Still need to figure out the part cooler, as none of the designs out there really fit.

More to come. I'll try to go back and fill in some of the step by step and link to all the resources I'm consulting.